SLATTACH(8)             386BSD System Manager's Manual             SLATTACH(8)

NAME
     slattach - attach serial lines as network interfaces

SYOPNSIS
     Slattach ttyname [baudrate]

DESCRIPTION
     Slattach is used to assign a tty line to a network interface, and to
     define the network source and destination addresses.  The following
     operands are supported by slattach:

     ttyname       Specifies the name of the tty device.  Ttyname should be a
                   string of the form `ttyXX', or `/dev/ttyXX'.

     baudrate      Specifies the speed of the connection. If not specified,
                   the default of 9600 is used.

     Only the super-user may attach a network interface.

     To detach the interface, use ``ifconfig interface-name down'' after
     killing off the slattach process.  Interface-name is the name that is
     shown by netstat(1)

EXAMPLES
           slattach ttyh8
           slattach /dev/tty01 4800

DIAGNOSTICS
     Messages indicating the specified interface does not exit, the requested
     address is unknown, the user is not privileged and tried to alter an
     interface's configuration.

SEE ALSO
     netstat(1),  netintro(4),  ifconfig(8),  rc(8)

HISTORY
     The slattach command appeared in 4.3BSD.

4.3 Berkeley Distribution       March 16, 1991                               1