dak(7) dak(7)
NAME
dak - Mylex DAC960 Array Controller
DESCRIPTION
The Mylex DAC960 EISA SCSI Disk Array Controllers are a high-
performance multiple channel controller for disk arrays. The
dak host adapter driver provides a Portable Device Interface
(PDI) compliant interface to the Mylex DAC960 adapter. The
supported devices include the DAC1CH-HBA_MYL-4, DAC3CH-
HBA_MYL-4, DAC5CHF-SCSI-4, and DAC960E-CH3-4.
The Mylex SCSI host adapter driver enables PDI compliant
target drivers (such as sd01, st01, and so on) to communicate
on the SCSI bus with target controllers and logical units.
This allows normal access to mass-storage devices using
standard system interfaces and filesystems.
It is also possible for a knowledgeable user to access the
SCSI-bus subsystem directly by using the driver's pass-through
interface. This allows the user to issue sb control blocks
directly to a SCSI target device. To find the appropriate
pass-through device to use for a particular target device, the
user should open(2) the character special file for the device
in question and then issue the B_GETDEV ioctl. The device
value returned should then be used to create a character
special file which, when opened, may be used for pass-through
(SDI_SEND ioctl).
ioctl Calls
The following ioctl(2) commands are provided by this driver:
SDI_SEND
Sends a pass-through command (SCSI control block) to a
target controller, bypassing the associated target
driver.
SDI_BRESET
Resets the SCSI bus.
B_GETTYPE
Returns the bus name (SCSI) and device driver name of a
specific device.
HA_VER
Returns a ver_no structure describing this driver.
Copyright 1994 Novell, Inc. Page 1
dak(7) dak(7)
Files
/usr/include/sys/dak.h
/usr/include/sys/scsi.h
/usr/include/sys/sdi.h
/usr/include/sys/sdi_edt.h
/usr/include/sys/sdi_comm.h
/etc/conf/pack.d/dak/space.c
REFERENCES
adsa(7), adsc(7), adse(7), adss(7), dpt(7), ioctl(2), mcis(7),
sc01(7), sd01(7), st01(7), sw01(7), wd7000(7)
NOTICES
Extreme caution should be exercised when using the pass-
through interface. It is possible to interfere with normal
system I/O and cause hangs if pass-through is used to an
active device. Pass-through should only be used to a device
that is otherwise quiescent.
Copyright 1994 Novell, Inc. Page 2