stdeq_agent(1M)                                      stdeq_agent(1M)


       NAME
             stdeq_agent - Compaq Insight Manager (CIM) Standard Equipment
             Agent

       SYNOPSIS
             stdeq_agent [-a] [-p time] [-i] [-r OK|NOTOK] [-s OK|NOTOK] [-t OK|NOTOK]

       DESCRIPTION
             stdeq_agent is the Compaq Insight Manager (CIM) Standard
             Equipment data collection agent.  This agent is responsible
             for populating hardware configuration information (disk,
             serial port, parallel port, etc.)  for the CIM MIB registered
             by cpqsmuxd(1M).  By default, the agent is started by cpqsmuxd
             with the arguments specified in the
             /usr/bin/compaq/smux/config file.

             stdeq_agent supports the following options:

             -a                specifies that stdeq_agent will be run as a
                               CIM agent.  When this option is not used,
                               stdeq_agent prints equipment information on
                               standard output.

             -p time           specifies the time, in seconds, between
                               updates of the MIB variables.  If not
                               specified, time defaults to 30 seconds.

             -i                tells the agent to ignore stop indication
                               from the cpqsmuxd process.  If this is not
                               specified, when a stop indication is
                               received from cpqsmuxd, stdeq_agent
                               terminates.

             -r OK | NOTOK     enables or disables the ability of the CIM
                               management station to reboot the server.
                               The default is NOTOK.

             -t OK | NOTOK     enables or disables the ability to send SNMP
                               traps.  If OK, stdeq_agent will issue SNMP
                               traps.

             -s OK | NOTOK     enables or disables set operations on this
                               agent's MIB variables.  A user at a
                               management station may attempt to set MIB
                               variables managed by this agent.  If OK, the
                               agent will allow set operations.


                           Copyright 1994 Novell, Inc.               Page 1

      stdeq_agent(1M)                                      stdeq_agent(1M)


      REFERENCES
            cpqsmuxd(1M)

      NOTICES
            This command is only supported on applicable Compaq systems.
            Refer to the Administration Supplement for Compaq Systems for
            more information.









































                          Copyright 1994 Novell, Inc.               Page 2