rrouter(1M) rrouter(1M)
NAME
rrouter - rebuild the router table
SYNOPSIS
rrouter
DESCRIPTION
The rrouter command rebuilds the IPX router table by
requesting route information from all known neighboring
routers.
You must be a privileged user to use rrouter. This utility is
normally not needed during the operation of the IPX protocol
stack. However, if a router has crashed, it may take several
minutes before its routes are removed from the routing table.
Running rrouter could speed up the process.
Using the rrouter utility could cause a momentary increase in
the amount of RIP traffic on the network.
SEE ALSO
drouter(1M)
Copyright 1994 Novell, Inc. Page 1