NAME

t_rcvuderr − receive a unit data error indication

SYNOPSIS

#include <tiuser.h>

int t_rcvuderr (int fd, struct t_uderr ∗uderr);

DESCRIPTION

This function is used in connectionless mode to receive information concerning an error on a previously sent data unit, and should be issued only after a unit data error indication.  It informs the transport user that a data unit with a specific destination address and protocol options produced an error.  fd identifies the local transport endpoint through which the error report will be received, and uderr points to a t_uderr structure containing the following members:

struct netbuf addr;
struct netbuf opt;
long error;

netbuf is described in intro(3N).  The maxlen [see netbuf in intro(3N)] field of addr and opt must be set before issuing this function to indicate the maximum size of the buffer for each. 

On return from this call, the addr structure specifies the destination protocol address of the erroneous data unit, the opt structure identifies protocol-specific options that were associated with the data unit, and error specifies a protocol-dependent error code. 

If the user does not care to identify the data unit that produced an error, uderr may be set to NULL and t_rcvuderr will simply clear the error indication without reporting any information to the user. 

On failure, t_errno may be set to one of the following:

TBADF The specified file descriptor does not refer to a transport endpoint. 

TNOUDERR No unit data error indication currently exists on the specified transport endpoint. 

TBUFOVFLW The number of bytes allocated for the incoming protocol address or options is not sufficient to store the information.  The unit data error information to be returned in uderr will be discarded. 

TNOTSUPPORT This function is not supported by the underlying transport provider. 

TSYSERR A system error has occurred during execution of this function. 

SEE ALSO

intro(3N), t_rcvudata(3N), t_sndudata(3N). 

DIAGNOSTICS

t_rcvuderr returns 0 on successful completion and −1 on failure and t_errno is set to indicate the error. 

  —  Networking Support Utilities