LPUSERS(1M)          INTERACTIVE UNIX System          LPUSERS(1M)



          NAME
               lpusers - set printing queue priorities

          SYNOPSIS
               /usr/lib/lpusers -d priority-level
               /usr/lib/lpusers -q priority-level -u user-list
               /usr/lib/lpusers -u user-list
               /usr/lib/lpusers -q priority-level
               /usr/lib/lpusers -l

          DESCRIPTION
               The lpusers command is used to set limits to the queue
               priority level that can be assigned to jobs submitted by
               users of the LP print service.

               The first form of the command (with -d) sets the system-wide
               priority default to priority-level, where priority-level is
               a value of 0 to 39, with 0 being the highest priority.  If a
               user does not specify a priority level with a print request
               [see lp(1)], the default priority is used.  Initially, the
               default priority level is 20.

               The second form of the command (with -q and -u) sets the
               default highest priority-level (0-39) that the users in
               user-list can request when submitting a print request.
               Users that have been given a limit cannot submit a print
               request with a higher priority level than the one assigned,
               nor can they change a request already submitted to have a
               higher priority.  Any print requests with priority levels
               higher than allowed will be given the highest priority
               allowed.

               The third form of the command (with -u) removes the users
               from any explicit priority level and returns them to the
               default priority level.

               The fourth form of the command (with -q) sets the default
               highest priority level for all users not explicitly covered
               by the use of the second form of this command.

               The last form of the command (with -l) lists the default
               priority level and the priority limits assigned to users.

          SEE ALSO
               lp(1).










          Rev.                                                       Page 1