Requires Optional SwitchOver/UX Software

NAME

switchsetflg − set the boot flags

SYNOPSIS

switchsetflg [-p |-s] hostname

Remarks:

This command requires installation of optional SwitchOver/UX software (not included in the standard HP-UX operating system) before it can be used. 

DESCRIPTION

switchsetflg sets the boot flags in stable storage as appropriate for the SwitchOver host type, primary or standby.  For a primary host, autoboot and autosearch are turned off.  For a standby host, autoboot is turned on.  switchsetflg is for use on SCSI configurations only.  Do not use on Fiber Link configurations. 

Options

-p Set the values as appropriate for a primary host. 

-s Set the values as appropriate for a standby host. 

If no options are specified, switchsetflg prints the current values of the autoboot and autosearch flags in stable storage. 

switchsetflg should be executed at bootup, normally from /etc/inittab.  switchsetflg is executed by each member of the SwitchOver/UX host group. 

AUTHOR

switchsetflg was developed by HP. 

SEE ALSO

switchheartb(1m), switchreadp(1m), switchsetlan(1m), switchdiskl(1m), switchinfo(4). 

Hewlett-Packard Company  —  HP-UX Release 9.03: April 1994