di10(1M)                                                           di10(1M)

NAME
     di10 - Imagen printer filter

SYNOPSIS
     di10 [option ...] [file ...]

DESCRIPTION
     di10 prints files created by troff(1M) on any printer that accepts the
     Impress graphics and page layout language. If no file is mentioned,
     the standard input is printed. The following options are understood:

     -olist Prints pages whose numbers are given in the comma-separated
            list. The list contains single numbers N and ranges N1 - N2. A
            missing N1 means the lowest-numbered page, a missing N2 means
            the highest.

     -xnum  Leaves a margin num inches from the left side edge of the
            paper.

     -ynum  Leaves a margin num inches down from the top of the page.

     -l     Prints the job in landscape mode.

     -pnum  Sets the horizontal and vertical step sizes for graphics to num
            pixels. If Impress graphics commands are used for drawing this
            option will only affect splines.

     -Pnum  Uses num as the pixel diameter of the Impress graphics pen.
            Only useful when Impress graphics commands are being used.

     -Tname Generates output to be printed on the target printer name. The
            only supported choice for name is i10.

     -Fdir  Uses dir as the troff font directory.

     -Bdir  Uses dir as the raster table directory.

     -Rname Uses raster tables generated for device name when printing
            file. By default di10 will attempt to use the target printer's
            raster files.

     The files should be prepared by troff. Best results will almost cer-
     tainly be obtained only when troff and di10 agree on the target
     printer.

FILES
     /usr/lib/font/devi10
     /usr/lib/font/devi10/rasti10

SEE ALSO
     troff(1M), troff(5).




Page 1                       Reliant UNIX 5.44                Printed 11/98