pefn(7) DG/UX 5.4.2 pefn(7)
NAME
pefn - Peregrine FDDI network interface
SYNOPSIS
pefn ([def]) or
pefn @devicecode (VMEA16addr)
DESCRIPTION
The pefn device driver allows an AViiON system that includes a V/FDDI
controller to access a Fiber Distributed Data Interface (FDDI)
network. To set up this interface, you enter one or more pefn
statements in the DG/UX system configuration file.
The pefn statement has two formats (shown above and illustrated
below). The first format accepts all defaults for a specified
controller board. The second format specifies all values:
def A number from 0 to 7, or null for 0, identifying the
controller board defaults to use
@devicecode The network controller device code, preceded by the @
character
VMEA16addr The VME A16 (short I/O) address of the controller
The pefn device is implemented as a clonable Streams driver. This
means that you can open a single node, such as /dev/pefn0, to access
any unused minor device. Each subsequent access of the node via the
open(2) system call allocates a separate Stream (minor number) to the
device driver.
DIAGNOSTICS
Use the -i option with netstat(1C).
EXAMPLES
The following entries in a DG/UX configuration file configure two
FDDI controllers with default values, at nodes /dev/pefn0 and
/dev/pefn1:
pefn(0)
pefn(1)
Note that either pefn() or pefn(0) will create the initial node.
The following statement configures an FDDI controller with device
code 7B and VME A16 address ffff2400:
pefn@7B(ffff2400)
For more information about DG/UX device configuration, refer to
Writing a Standard Device Driver for the DG/UX (Trademark) System
(093-701053).
For a full discussion of device naming conventions and a list of
Licensed material--property of copyright holder(s) 1
pefn(7) DG/UX 5.4.2 pefn(7)
board defaults, see Customizing the DG/UX (Trademark) System
(093-701101).
SEE ALSO
ifconfig(1M), netinit(1M), system(4), arp(6P), intro(7), inet(6F).
Licensed material--property of copyright holder(s) 2