t_accept(3N) DG/UX 5.4.2 t_accept(3N)
NAME
taccept - accept a connect request
SYNOPSIS
#include <tiuser.h>
int taccept ( int fd, int resfd, struct tcall *call);
DESCRIPTION
This function is issued by a transport user to accept a connect
request. fd identifies the local transport endpoint where the
connect indication arrived, resfd specifies the local transport
endpoint where the connection is to be established, and call contains
information required by the transport provider to complete the
connection. call points to a tcall structure that contains the
following members:
struct netbuf addr;
struct netbuf opt;
struct netbuf udata;
int sequence;
netbuf is described in intro(3). In call, addr is the address of the
caller, opt indicates any protocol-specific parameters associated
with the connection, udata points to any user data to be returned to
the caller, and sequence is the value returned by tlisten that
uniquely associates the response with a previously received connect
indication.
A transport user may accept a connection on either the same, or on a
different, local transport endpoint from the one on which the connect
indication arrived. If the same endpoint is specified (i.e.,
resfd=fd), the connection can be accepted unless the following
condition is true: The user has received other indications on that
endpoint but has not responded to them (with taccept or tsnddis).
For this condition, taccept will fail and set terrno to TBADF.
If a different transport endpoint is specified (resfd!=fd), the
endpoint must be bound to a protocol address and must be in the
TIDLE state [see tgetstate(3N)] before the taccept is issued.
For both types of endpoints, taccept will fail and set terrno to
TLOOK if there are indications (e.g., a connect or disconnect)
waiting to be received on that endpoint.
The values of parameters specified by opt and the syntax of those
values are protocol specific. The udata argument enables the called
transport user to send user data to the caller and the amount of user
data must not exceed the limits supported by the transport provider
as returned in the connect field of the info argument of topen or
tgetinfo. If the len [see netbuf in intro(3)] field of udata is
zero, no data will be sent to the caller.
On failure, terrno may be set to one of the following:
Licensed material--property of copyright holder(s) 1
t_accept(3N) DG/UX 5.4.2 t_accept(3N)
[TBADF] The specified file descriptor does not refer to a
transport endpoint, or the user is illegally
accepting a connection on the same transport
endpoint on which the connect indication arrived.
[TOUTSTATE] The function was issued in the wrong sequence on
the transport endpoint referenced by fd, or the
transport endpoint referred to by resfd is not in
the TIDLE state.
[TACCES] The user does not have permission to accept a
connection on the responding transport endpoint or
use the specified options.
[TBADOPT] The specified options were in an incorrect format
or contained illegal information.
[TBADDATA] The amount of user data specified was not within
the bounds allowed by the transport provider.
[TBADSEQ] An invalid sequence number was specified.
[TLOOK] An asynchronous event has occurred on the
transport endpoint referenced by fd and requires
immediate attention.
[TNOTSUPPORT] This function is not supported by the underlying
transport provider.
[TSYSERR] A system error has occurred during execution of
this function.
SEE ALSO
intro(3), tconnect(3N), tgetstate(3N), tlisten(3N), topen(3N),
trcvconnect(3N).
UNIX System V Network Programmer's Guide.
DIAGNOSTICS
Upon successful completion, a value of 0 is returned. Otherwise, a
value of -1 is returned and terrno is set to indicate the error.
Licensed material--property of copyright holder(s) 2