[SCA Command] Creates an analysis data file that describes a
   source file.

   Format

     ANALYZE   file-spec[,...]

Additional information available:

QualifiersParameter

Additional information available:

/DESIGN/LANGUAGE/LOG/OUTPUT

      /DESIGN[=design-option]
      /NODESIGN (D)

   Indicates that the source file should be processed as a program
   design language. The design options are as follows:

   COMMENTS        The ANALYZE command looks inside comments for
                   design information. Information about comments
                   is included in the analysis data file. Any errors
                   detected are reported

   NOCOMMENTS      The ANALYZE command ignores comments.

   PLACEHOLDERS    The ANALYZE command treats LSE placeholders as
                   valid syntax. Placeholders are reported in the
                   analysis data file.

   NOPLACEHOLDERS  The ANALYZE command does not report placeholders
                   in the .ANA file. It does not report errors if
                   placeholders are encountered.

   If you specify the /DESIGN qualifier, the default is /DESIGN=
   (COMMENTS,PLACEHOLDERS). If you do not specify this qualifier, the
   default is /NODESIGN.

      /LANGUAGE=language

   Specifies the language of the source file. By default, the
   language is that which is specified by the file type of the source
   file.

      /LOG (D)
      /NOLOG

   Indicates whether each analyzed file is reported.

      /OUTPUT[=file-spec]
      /OUTPUT=file-name.ANA (D)

   Specifies the analysis data file to be created. The default is
   /OUTPUT=
   filename.ANA, where file-name is the name of the first source file
   specified as the parameter to this command.

file-spec[,...]
   Specifies the files to be analyzed. You can use wildcards with the
   file-spec parameter. Within LSE, the current buffer is analyzed by
   default.