=TITLE ANALYZE
 [SCA Command] Creates an analysis data file that
 describes a source file.

 Format

     ANALYZE   file-spec[,...]

Additional information available:

QualifiersParameter

=TITLE Qualifiers

Additional information available:

/DESIGN/LANGUAGE/LOG/OUTPUT

    /DESIGN[=design-option]
    /NODESIGN (D)

 Indicates that the source file should be processed as
 a program design language. The design options are as
 follows:

 COMMENTS        The ANALYZE command looks inside
                 comments for design information.
                 Information about comments is included
                 in the analysis data file. Any errors
                 detected are reported

 NOCOMMENTS      The ANALYZE command ignores comments.

 PLACEHOLDERS    The ANALYZE command treats LSE
                 placeholders as valid syntax.
                 Placeholders are reported in the
                 analysis data file.

 NOPLACEHOLDERS  The ANALYZE command does not report
                 placeholders in the .ANA file. It does
                 not report errors if placeholders are
                 encountered.

 If you specify the /DESIGN qualifier, the default is
 /DESIGN=
 (COMMENTS,PLACEHOLDERS). If you do not specify this
 qualifier, the default is /NODESIGN.

    /LANGUAGE=language

 Specifies the language of the source file. By default,
 the language is that which is specified by the file
 type of the source file.

    /LOG (D)
    /NOLOG

 Indicates whether each analyzed file is reported.

    /OUTPUT[=file-spec]
    /OUTPUT=file-name.ANA (D)

 Specifies the analysis data file to be created. The
 default is /OUTPUT=
 filename.ANA, where file-name is the name of the first
 source file specified as the parameter to this command.

=TITLE Parameter

file-spec[,...]
 Specifies the files to be analyzed. You can use
 wildcards with the file-spec parameter. Within LSE,
 the current buffer is analyzed by default.