SPELL

 Runs DECspell (if it is installed on your system) to check the currently
 selected text or the entire buffer.

 Note:  The SPELL command is not supported on DECwindows unless you invoke
        EVE with the /DISPLAY=CHARACTER_CELL qualifier.

 Steps:

    1.  Optionally, select the text you want to check.

    2.  Use the SPELL command or with the WPS keypad, press GOLD-S.

    3.  Use DECspell commands to correct your text.  After making your
        corrections, exiting from DECspell resumes your editing session.

 o  EVE spawns a subprocess to run DECspell and writes out the current
    buffer or select range to a temporary file in SYS$SCRATCH.

 o  When you exit from DECspell, EVE replaces the buffer or range with the
    new version of the temporary file, containing any corrections, and
    deletes the temporary file.

 o  If you select less than a full line, EVE extends the select range to
    include the start and end of the line.  If you do NOT select any text,
    SPELL checks the entire buffer.

 o  Do NOT use CTRL/Y while using SPELL.  This deletes lines in the
    temporary output file, and therefore destroys the selected range or
    current buffer.