Displays the values of system parameters in the SYSGEN work area, plus
the minimum, maximum, and default values of the parameters, and their
units of measure.  Can also display the I/O driver database.

Format
    SHOW parameter-name
    SHOW /parameter-type
    SHOW /DEVICE=driver-name
    SHOW /HEX parameter-name
    SHOW /HEX/parameter-type

Additional information available:

parameter-nameQualifiers

Name of a system parameter.  Use the SHOW /NAMES command to obtain the
names of all the system parameters.

Additional information available:

/ACP/ADAPTER/ALL/CLUSTER/CONFIGURATION/DEVICE
/DRIVER/DYNAMIC/GEN/HEX/JOB/LGI/MAJOR
/NAMES/PQL/RMS/SCS/SPECIAL/STARTUP/SYS
/TTY/UNIBUS

Displays the system parameters that affect the disk and magnetic tape
ancillary control processes (ACP's).

Displays a list of adapters and what is connected to each nexus.

Displays all the system parameters.

Displays the parameters that are associated with a VAX cluster.

Shows devices by name, number of units, nexus number, adapter type,as
well as CSR and vectors addresses.

                CMEXEC privilege required

 Also accepts /ADAPTER = adapter-spec, /OUTPUT = file-spec, as well as
 /COMMAND_FILE, which formats all the devices as CONNECT commands to
 allow a complete re-configuration of a system's UNIBUS without the use of
 AUTOCONFIGURE.

Displays the device data base associated with a particular I/O device
driver; if no device driver is specified, the database for all drivers
is displayed.

                CMEXEC privilege required

A short form of the /DEVICE display, only giving the beginning and ending
addresses of the drivers.

Displays the system parameters that can be modified in the active running
system.  See WRITE ACTIVE for how to modify these parameters.

Displays the structure-generating parameters and other parameters that
take effect only at boot time.

Displays the values in base 16.

Displays the job controller parameters.

Displays all login parameters.

Displays the major parameters.  These are the parameters that are most
likely to require adjustment for individual installations.

Displays just the names of all the parameters.

Displays the parameters that are used as the minimum and default for
process creation limits and quotas.

Displays the parameters that are used as the system-wide defaults for
VAX-11 RMS.

Displays the parameters that are associated with the system communications
services.

Displays the parameters that generally need never be changed.

Displays the name of the current site-independent startup
command procedure.

Displays the parameters that are associated with overall system operation.

Displays the parameters that are associated with the terminal driver.

Tests every word in UNIBUS I/O space and returns a list of addresses
that respond and the value that was read. Note that this command is
useful for debugging UNIBUS autoconfigure problems, but it is not
recommended for use on a running system. All unibus adapters are the
default, /ADAPTER=adapter-spec can be specified.

                CMKRNL privilege required