NAME

dd − convert and copy a file

SYNOPSIS

dd [option=value] ... 

DESCRIPTION

Dd copies the specified input file to the specified output with possible conversions.  The standard input and output are used by default.  The input and output block size may be specified to take advantage of raw physical I/O. 

option values

if=file input file name; standard input is default

of=file output file name; standard output is default

ibs=n input block size n bytes (default 512)

obs=n output block size (default 512)

bs=n set both input and output block size, superseding ibs and obs; also, if no conversion is specified, it is particularly efficient since no in-core copy need be done

cbs=n conversion buffer size

skip=n skip n input records before starting copy

seek=n seek n records from beginning of output file before copying

count=n copy only n input records

conv=ascii convert EBCDIC to ASCII

ebcdic convert ASCII to EBCDIC

ibm slightly different map of ASCII to EBCDIC

lcase map alphabetics to lower case

ucase map alphabetics to upper case

swab swap every pair of bytes

noerror do not stop processing on an error

sync pad every input record to ibs

... , ... several comma-separated conversions

Where sizes are specified, a number of bytes is expected.  A number may end with k, b, or w to specify multiplication by 1024, 512, or 2 respectively; a pair of numbers may be separated by x to indicate a product. 

Cbs is used only if ascii or ebcdic conversion is specified.  In the former case cbs characters are placed into the conversion buffer, converted to ASCII, and trailing blanks trimmed and new-line added before sending the line to the output.  In the latter case ASCII characters are read into the conversion buffer, converted to EBCDIC, and blanks added to make up an output record of size cbs.

After completion, dd reports the number of whole and partial input and output blocks. 

EXAMPLE

This command will read an EBCDIC tape blocked ten 80-byte EBCDIC card images per record into the ASCII file x:

dd  if=/dev/rmt0  of=x  ibs=800  cbs=80  conv=ascii,lcase

Note the use of raw magtape.  Dd is especially suited to I/O on the raw physical devices because it allows reading and writing in arbitrary record sizes. 

SEE ALSO

cp(1). 

DIAGNOSTICS

f+p records in(out)numbers of full and partial records read(written)

BUGS

The ASCII/EBCDIC conversion tables are taken from the 256 character standard in the CACM Nov, 1968.  The ibm conversion, while less blessed as a standard, corresponds better to certain IBM print train conventions.  There is no universal solution. 

New-lines are inserted only on conversion to ASCII; padding is done only on conversion to EBCDIC.  These should be separate options. 

May 16, 1980