Why didn't you put Ethernet on the BeBox motherboa
|
![[Bar]](../../graphics/black_bar.gif)
|
|
The BeBox
General
Why didn't you put Ethernet on the BeBox motherboard?
|
The BeBox:
General
|
FAQ Number:
FAQ-0116
|
Last Modified:
2/3/98
|
Keywords:
BeOS,
BeBox,
design,
philosophy,
Ethernet,
expansion,
network,
built-in
|
|
We did not want to lock anyone in to a specific networking protocol or hardware. The ISA and PCI slots allow you to configure the network you need, based on your other installed equipment or network. On-board networking would have restricted you, and in all likelihood cost you more (in buying the BeBox) than picking up your own networking card.
We support NE2000-type Ethernet cards, which are available from a number of vendors, and which have been seen for as little as $19.95 -- retail! We also believe that users should be able to choose their own network -- be it a modem, ISDN, Ethernet, Fast Ethernet, or ATM.
|
|
|
Copyright ©1998 Be, Inc.
Be is a registered trademark, and BeOS, BeBox, BeWare, GeekPort, the Be logo
and the BeOS logo are trademarks of Be, Inc. All other trademarks mentioned
are the property of their respective owners.
Icons used herein are the property of Be Inc. All rights reserved.
Comments about this site? Please write us at webmaster@be.com.
|
