ROUTE(8C)

NAME

route − manually manipulate the routing tables

SYNOPSIS

/etc/route [−f] [−n] [command args]

DESCRIPTION

Route is a program used to manually manipulate the network routing tables. It normally is not needed, as the system routing table management daemon, routed(8C), should tend to this task.

Route accepts three commands: add, to add a route; addp, to add a priority route; and delete, to delete a route.

The addp command adds a priority route. The TCP/IP server process will use priority routes before default routes or routes established by routed(8C). A route added with addp will appear first in the gateway table (displayed with the DOMAIN/IX command netstat -r(1)). You can only add priority routes with addp. Routes added manually by route cannot be deleted by routed(8C).

All commands have the following syntax:

/etc/route command [ net | host ] destination gateway [ metric ]

where destination is the destination host or network, gateway is the next-hop gateway to which packets should be addressed, and metric is a count indicating the number of hops to the destination. The metric is required for add and addp commands; it must be zero if the destination is on a directly-attached network, and nonzero if the route utilizes one or more gateways. If adding a route with metric 0, the gateway given is the address of this host on the common network, indicating the interface to be used for transmission.

Routes to a particular host are distinguished from those to a network by interpreting the Internet address associated with destination. The optional keywords net and host force the destination to be interpreted as a network or a host, respectively. Otherwise, if the destination has a “local address part” of INADDR_ANY, or if the destination is the symbolic name of a network, then the route is assumed to be to a network; otherwise, it is presumed to be a route to a host.

If the route is to a destination connected through a gateway, the metric should be greater than 0. All symbolic names specified for a destination or gateway are looked up first as a host name using gethostbyname(3N). If this lookup fails, getnetbyname(3N) is then used to interpret the name as that of a network.

You can add a default route as follows:

/etc/route add default gateway_name [non-zero metric]

Tcp_server will use the default route when other routes occuring earlier in the routing table have failed, or when there are no other possible routes.

Route uses a raw socket and the SIOCADDRT and SIOCDELRT ioctl’s(2) to do its work. As such, only the super-user may modify the routing tables.

OPTIONS

−f “Flush” the routing tables of all gateway entries. Using this option in conjunction with one of the commands described above flushes the tables prior to the command’s application.

−n Suppress printing symbolic host and network names when reporting actions.

DIAGNOSTICS

“add [ host | network ] %s: gateway %s flags %x” The specified route is being added to the tables. The values printed are from the routing table entry supplied in the ioctl(2) call. If the gateway address used was not the primary address of the gateway (the first one returned by gethostbyname(3N)), the gateway address is printed numerically as well as symbolically.

“delete [ host | network ] %s: gateway %s flags %x” As above, but when deleting an entry.

“%s %s done” When the −f flag is specified, each routing table entry deleted is indicated with a message of this form.

“Network is unreachable” An attempt to add a route failed because the gateway listed was not on a directly-connected network. The next-hop gateway must be given.

“not in table” A delete operation was attempted for an entry that wasn’t present in the tables.

“routing table overflow” An add operation was attempted, but the system was low on resources and was unable to allocate memory to create the new entry.

Museum