10.4;trpt , revision 2.0, 91/10/14
trpt  -transliterate protocol trace
usage: trpt [-a] [-c] [-a <PCB addr>] [-e] [-f] [-j] [-l] [-m] [-s]
[-t] [-u] [-w] [-W] [-p <PCB addr>] [<filename>]



DESCRIPTION
     trpt interrogates the buffer of TCP trace records created when a socket
     is marked for "debugging" (see setsockopt), and prints a readable
     description of these records.  When no options are supplied, trpt prints
     all the trace records found in the system, grouped according to TCP
     connection protocol control block (PCB).  The following options may be
     used to alter this behavior.

OPTIONS
     -a             Print the values of the source and destination addresses
                    for each packet recorded in addition to the normal output.

     -f             Follow the trace as it occurs, waiting a short time for
                    additional records each time the end of the log is
                    reached.

     -j             Just give a list of the protocol control block addresses
                    for which there are trace records.

     -p <PCB addr>  Show only trace records associated with the protocol
                    control block, the address of which follows.

     -s             Print a detailed description of the packet sequencing
                    information in addition to the normal output. (Currently
                    unimplemented)

     -t             Print the values for all timers at each point in the trace
                    in addition to the normal output. (Currently
                    unimplemented)

Domain/OS Aegis EXTENSIONS
     -c             Clear trace buffer.

     -d <PCB addr>  Toggle debug on a connection.

     -e             Exit on a bad trace record.

     -l             Print lapsed times in addition to the normal output.

     -m             Print output values in decimal format.

     -u             Print output values in unsigned decimal format.

     -w             Warn on bad trace records.

     -W             Print extra information describing the state of the
                    offered window at the time each packet is processed.

NOTES
     The recommended use of trpt is as follows.  Isolate the problem and
     enable debugging on the socket(s) involved in the connection.  Find the
     address of the protocol control blocks associated with the sockets using
     the -A option to netstat.  Then run trpt with the -p option, supplying
     the associated protocol control block addresses.  The -f option can be
     used to follow the trace log once the trace is located.  If there are
     many sockets using the debugging option, the -j option may be useful in
     checking to see if any trace records are present for the socket in
     question.

     If debugging is being performed on a file other than the default, which
     is `nodedata/systmp/tcpdata, <filename> may be used to specify another
     file.

BUGS
     trpt should print the data for each input or output, but this is not
     saved in the trace record.

     The output format is inscrutable.

FILES
     `nodedata/systmp/tcpdata

SEE ALSO
     setsockopt, netstat;
     Configuring and Managing TCP/IP.