KILL(2)
NAME
kill − send a signal to a process or a group of processes
SYNOPSIS
int kill (pid, sig)
int pid, sig;
DESCRIPTION
Kill sends a signal to a process or a group of processes. The process or group of processes to which the signal is to be sent is specified by pid. The signal that is to be sent is specified by sig and is either one from the list given in signal(2), or 0. If sig is 0 (the null signal), error checking is performed but no signal is actually sent. This can be used to check the validity of pid.
The effective user ID of the sending process must match the real user ID of the receiving process unless, the effective user ID of the sending process is super-user, or the process is sending to itself.
The processes with a process ID of 0 and a process ID of 1 are special processes (see intro(2)) and will be referred to below as proc0 and proc1 respectively.
If pid is greater than zero, sig will be sent to the process whose process ID is equal to pid. Pid may equal 1.
If pid is 0, sig will be sent to all processes excluding proc0 and proc1 whose process group ID is equal to the process group ID of the sender.
If pid is −1 and the effective user ID of the sender is not super-user, sig will be sent to all processes excluding proc0 and proc1 whose real user ID is equal to the effective user ID of the sender.
If pid is −1 and the effective user ID of the sender is super-user, sig will be sent to all processes excluding proc0 and proc1.
If pid is negative but not −1, sig will be sent to all processes whose process group ID is equal to the absolute value of pid.
Kill will fail and no signal will be sent if one or more of the following are true:
Sig is not a valid signal number. [EINVAL]
No process can be found corresponding to that specified by pid. [ESRCH]
The sending process is not sending to itself, its effective user ID is not super-user, and its effective user ID does not match the real user ID of the receiving process. [EPERM]
RETURN VALUE
Upon successful completion, a value of 0 is returned. Otherwise, a value of −1 is returned and errno is set to indicate the error.