NAME

/usr/5bin/col − filter reverse line feeds

SYNOPSIS

/usr/5bin/col [ −bfpx ]

DESCRIPTION

Col reads the standard input and writes the standard output.  It performs the line overlays implied by reverse line feeds (ESC-7 in ASCII) and by forward and reverse half line feeds (ESC-9 and ESC-8). 

Although col accepts half line motions in its input, it normally does not emit them on output.  Instead, text that would appear between lines is moved to the next lower full line boundary.  This treatment can be suppressed by the −f (fine) option; in this case the output from col may contain forward half line feeds (ESC-9), but will still never contain either kind of reverse line motion. 

If the −b option is given, col assumes that the output device in use is not capable of backspacing.  In this case, if several characters are to appear in the same place, only the last one read will be taken. 

The control characters SO (ASCII code 017), and SI (016) are assumed to start and end text in an alternate character set.  The character set (primary or alternate) associated with each printing character read is remembered; on output, SO and SI characters are generated where necessary to maintain the correct treatment of each character. 

Unless the −x option is given, col converts white space to tabs to shorten printing time. 

All control characters are removed from the input except space, backspace, tab, return, newline, ESC (033) followed by one of 7, 8, 9, SI, SO, and VT (013).  This last character is an alternate form of full reverse line feed, for compatibility with some other hardware conventions.  All other non-printing characters are ignored. 

Normally, col will remove any unknown escape characters found in its input; the −p option may be used to force these through unchanged.  The use of this option is discouraged unless the user is fully aware of the consequences. 

SEE ALSO

troff(1), tbl(1)

BUGS

Can’t back up more than 128 lines. 
No more than 800 characters, including backspaces, on a line.

7th Edition